Difference between revisions of "Matrix Daughterboards"

From PTI Security Systems
Jump to: navigation, search
m (1 revision)
m
 
(One intermediate revision by the same user not shown)
Line 15: Line 15:
 
== Notes about the Matrix Daughterboard ==
 
== Notes about the Matrix Daughterboard ==
  
When these daughterboards are used in a [[Digitech Multiplexers|Unimux]], it is always provided with 4 of them installed plus one [[Relay Daughterbords|relay daughterboard]].  All 4 of the installed matrix daughterboards must have the same firmware version.
+
When these daughterboards are used in a [[Digitech Multiplexers|Unimux]], it is always provided with 4 of them installed plus one [[Relay Daughterboards|relay daughterboard]].  All 4 of the installed matrix daughterboards must have the same firmware version.

Latest revision as of 08:10, 13 August 2015

A member of the DigiWin - Syscon system.

UniMux Matrix Door-200x300.png

Used inside of a Unimux. There are 4 configuration types for this daughterboardModules that are installed in a Digitech Unimux. There are 3 different types of daughterboards, each with a different function., determined by the version of the firmware on it's socketed chip:

1: Connection to alarm inputs, through a Matrix Wire Trunk alarm network. This is only used when replacing an existing Digitech Matrix Door Alarm Board

2: Connection of Digitech Standard Keypads using a code* format for codes entered at the keypads.

3: Connection of Digitech Standard Keypads using a code# format for codes entered at the keypads.

4: Connection of Digitech Standard Keypads using a *code# format for codes entered at the keypads.

Notes about the Matrix DaughterboardModules that are installed in a Digitech Unimux. There are 3 different types of daughterboards, each with a different function.

When these daughterboards are used in a Unimux, it is always provided with 4 of them installed plus one relay daughterboard. All 4 of the installed matrix daughterboards must have the same firmware version.